2-Way Alarm System

Description:

The Introduction of the FCS-1 Software and Functions When executing the FCS.EXE software, the computer screen will show following diagram: After setting up the No.1 to 33 switches in the software, double click the MODIFY button ( button 51 ) for changing the MB function setting. The whole procedure will take about 15-30 seconds, after changing the functions, the MB will beep-beep-beep to show the change is successful. Re-register the RC ( Remote Controller ) with MB to complete the whole procedure. Operating Function Introduction (1) Option of Door motors drive time ( Sec.): (IO Port-Pin15/Pin16, P.9 )central door lock control timing 0.8 or 3.5 seconds option. (2) Option of Arm, door switch delay time (Sec.): (IO Port-Pin2/Pin6, P.8 ) dome light delay 6 or 30 seconds to light up after Arm. (3) Option of Disarm, Dome Light on (Sec.): dome light lights up 15 or 6 second after Disarm ( depends on models ). (4) Option of Auto door lock by Speed or Foot-brake: to lock car doors automatically when driving ( controlled by speed or brake pedal ) (5) Option of the driver of auto door lock speed: (IO Port-Pin 10, P.11) car speed control wire divided by 1 or 2 . Most car series auto door lock speed is 20 km, divided by 1, for other car series (such as : Nissan series) auto door lock speed might be 40 km, then divided by 2, but the auto door lock speed could be changed to 20km also. (6) Option of siren output : (IO Port-Pin 14, P.10)continuously or discontinuously. (7) Option of Temperature display: in Celsius ()or Fahrenheit ( ) (8) Option of Engine-Start, IGNI pre-warm up: (Power Port-Pin 6, P.6) start the engine by remote controller, INGI pre-heat for 4 or 6 Sec. (9) Option of Auto Engine Start by time / temperature: To start the engine at the setting time or setting temperature. (10) Option of Manual transmission / Auto transmission. (20) Option of Turbo Timer delay time: keep engine running time after starting Turbo-timer ( Setting 0 means disable Turbo-timer function ) (21) Option of Turbo timer start after driving more than how many minutes. (22) Option of 2 way RC low battery alert: whether there is a alert when open the car door after pressing the disarm key while the RC battery is low. (23) Option of V off ( pin12 ) function as V OFF or Arm active 30 Sec.: ( IO Port -Pin 12, P.12) to be V off output while fuel / electric power is off or be the second ARM-OUT output ( 30 Sec. ) (25) Option of the start motor timing: using RC to remote start the engine or start the engine automatically , the motor start time. (30) Option of Trunk trigger: ( IO Port-Pin4, P11) Trunk input signals , +/- trigger. (31) Option of Hood trigger : ( IO Port-Pin7, P11) Hood input signal, +/- trigger. (32) Option of Brake Pedal : ( IO Port-Pin8, P10) Foot Brake input signal, +/- trigger. (33) Option of Hand Brake trigger : ( IO Port-Pin9, P10) Hand Brake input signal, +/- trigger. (51) Modify: to execute the functions change (52) Read Status: to read the Main Board functions setting. (53) Exit: to exit after the functions changed completed. (54) Help: to explain all the functions.