1. FEATURES AND SPECIFICATIONS
The Type Intelligent Battery Guard continually monitors the battery
charge, and automatically disconnects the battery from the
electricity system if it detects that the power is falling below
the level that is required to start the engine. The power will be
reconnected by pressing and releasing the RESET button of the
Step 1:Turn the ON/OFF yellow knob on the top of the unit to the ON
Step 2: Disconnecting The Battery Cables
A) Disconnect the black negative cable from the negative post
on the battery.
B) Disconnect the red positive cable from the positive post
on the battery.
Step 3: Connecting the Intelligent Battery Guard
A: Connect the Positive Clamp set on the positive side of the
Intelligent Battery Guard, the
positive side of the Intelligent
Battery Guard is located on the side of the unit that has 12V+
printed on it.
B: Connect the Aluminum Positive Post set on the other side
of the Intelligent Battery Guard.
C: Connect the positive clamp onto the battery.
A: Connect the red/positive battery cable to the aluminum
post on the outer bracket of the
Intelligent Battery Guard.
B: Connect the black negative battery cable to the negative
post on the battery.
C: Connect the clip end of the black ground wire to the clamp
bolt on the negative post on
Step 4: Accessory Bypass Wire Installation
A. Slide the connecter end of the Bypass wire onto the
Butterfly Connector On the female positive
post of Intelligent Battery Guard.
B. Locate the motor's fuse box and the desired fuse.
C. Remove the fuse and insert it into the fuse connection in
the bypass wire.
D. Connect the exposed end of the bypass wire into the
outbound leg of the fuse box to activate
Step 5: Disabling connection/motor on wire installation
A. Locate a fuse in the fuse box that has current when the
motor is turned on and no current when
the motor is turned off. This wire can be
connected directly to the key switch.
B. Remove fuse.
C. Connect the exposed end of the bypass wire into the fuse
D. Slide the connector end of the bypass wire onto the single
connector on the negative side of
the Intelligent Battery Guard. The
connector is marked ACC .
3. TEST INSTALLATION RESULT
To test successful installation
Start the vehicle after installation is completed.
To test Intelligent Battery Guard operation
Turn the Vehicle off and turn on as many electrical accessories
(i.e. lights, radio,) as possible and leave them on. The
intelligent Battery Guard will cut power form the battery
automatically confirming it is working. This may take some time,
depending on the battery's age and charge.
To test manual reset function
Ensure that the yellow Manual reset control knob is in the ON
position and press it down after the Intelligent Battery Guard had
disconnected the power, the unit should re-establish power to the
electrical accessories and enable you to start the vehicle.
Remote control instructions and test:
Let's introduce all buttons & functions of the remote control
unit and test the functions:
1. Lock Symbol button Disconnect. Press and hold this
button for 2 seconds in order to
disconnect power between the vehicle and
the battery. The unit then becomes an antitheft
device and could not start.
2. Unlock symbol button Reconnect. Press and hold the reset
button for 2 seconds in order
to reconnect the unit and start the
4. IMPORTANT NOTICE
If a warning light for NO CHARGE or BATTERY WARNING illuminates on
your vehicle dashboard, stop your vehicle at a safe area and turn
the yellow knob to one of OFF positions, your vehicle will
experience a complete loss of power unless the NO CHARGE problem is
repaired immediately! This problem is unrelated to the intelligent
Battery Guard and requires assistance from an Auto Technician.